 |
 |
|
|
In order to view the technical and the safety data sheet you need the
Adobe Acrobat Reader software.
Click on the icon below in order to download it.
|
|
|
|
 |
|
|
|
|
|
|
|
|
|
|
| Code |
|
|
|
| Cod. 1295 |
Gas Heating Iron |
|
|
| Description |
|
|
|
The Borma Heating Iron is the best tool for the application of the Borma Hard Wax because of its sturdiness, small dimension and versatility.
It respects the colours and does not burn the polish. |
|
| How to use |
|
|
|
| TO REFILI |
| The gas switch must be in the OFF position and the iron kept with the
tip pointing downward, Connect the cylinder to the gas valve, keeping
this as well as the tool in a vertical position, until a light spillage occurs
indicating that the re-charge has been completed. |
|
| TO ACTIVATE |
| Place the reguiation valve in the Medium position keep the iron well
away from your tace and body and push the switch towards the point
of the iron. With the other hand activate the spark directing the same on
the aeration slits on the tip wbich will ignite for few seconds and than
go off by itscif You can check that the iron i s switched ON by verifying
that the filaments, seen through the aeration slits, are incandescenti Be
very careful not to touch the metal tip, at any time, even when you con
sider that the iron has not been activated, to avoid any danger of burns. |
|
| TO REGULATE |
| Use the valve marked +/- te regulate the temperature.
The ideal temperature is best verified by application, using a sample of
hard wax, It is not necessari for the tip to be red hot in order to
achieve the correct temperature. Il is recommended that Borma Har d
Wax is applied with medium/low temperature in order to preserve both
the quality of the wax and the stability of the colour.The soldering point
is composed of a threaded part and the filaments (catalyst),
both replaceable.
Despite its sturdiness, it is recommended to handie the iron with care
and to keep it out of children reach. Remember that the iron contains
combustible gas, under pressure.
Don't rest the iron on any surface until the flame is completely off.
Before handling the iron, before refilling and placing back its lid,
ensure that the tool is switched OFF and the point is completely cold,
The Borma heating iron should not be used at room temperature
exceeding +50C. For safety reasons do not mishandle the tool (avoid
forceful actions, drilling or overheating/burning). |
|
|
|
